911 Targa (996) F6-3.6L (2004)
1. Install in reverse order.
2. Install sucking jet pump. Before installing the sucking jet pump, fit (clip on) the retainer -arrow- at the connection -C-. Push the connection -C- on
to the angle piece as far as the stop.
Note!
^
The connection -C- of the sucking jet pump must be pushed completely (as far as the stop) -dashed line on to the angle piece (the connection
flange)!
^
As this area is not visible, it must be done by feel!
3. Carry out the following assembly operations:
-
Clip the lead into the holder -2-.
-
Fit hose -3-.
-
Push on plug -4-.
-
Fit the lead -A- for the brake booster and the snap ring -arrow-.
-
Fit the clamp and fasten with screw (M6) -5-.
4. Raise engine with the workshop jack and secure the engine carrier on the right and left engine mounts -arrow = left engine mount- with new
fastening nuts. Tightening torque 85 Nm (63 ft. lbs.).