911 Targa (996) F6-3.6L (2004)
5. If the allocation is correct, the narrow segment must face the cylinder head cover on the opposite side of the cylinder head.
6. Fasten blocking device (special tool 9612) on the cylinder head (4 - 6).
7. Perform following assembly steps for timing adjustment as described from Step 7 to Step 11.
8. Fit oil extraction pumps
Note;
-
The oil extraction pumps on the cylinder heads are identical parts. Therefore, the installation position and direction of rotation must be correct.
Installation position of oil extraction pump at cylinder head 1 - 3 (flywheel side).
The arrow for the direction of rotation or the marking "1 - 3" must face the crankcase.
Fit oil extraction pump. Use new sealing ring and new micro-encapsulated hexagon socket head screws.
Tightening torque: 10 Nm (7.5 ft. lbs.)
Installation position of oil extraction pump at cylinder head 4 - 6 (belt pulley side).
The arrow for the direction of rotation or the marking "4 - 6" must face the crankcase.
Fit oil extraction pump. Use new sealing ring and new micro-encapsulated hexagon socket head screws.
Tightening torque: 10 Nm (7.5 ft. lbs.)
9. Unscrew auxiliary chain tensioner, put new sealing ring on the original chain tensioner and install.
Tightening torque: 80 Nm (59 ft. lbs.) (Wrench size 30 mm.)
Note;