911 Targa (996) F6-3.6L (2004)
Checking camshafts of cylinder bank 4 - 6
1. Remove fixing pin. Move camshafts of cylinder bank 4 - 6 to basic position. Turn crankshaft clockwise until the bore 1 TDC (top dead centre) in
the belt pulley is aligned with the fixing bore on the crankcase. Position or fix with fixing pin (short) of special tool 9595 or 9595/1.
2. Check basic camshaft position of cylinder bank 4 - 6. The groove in the camshaft must face inward towards the crankcase.
View from the belt pulley side
3. If the allocation is correct, at the same time, the narrow segment of the exhaust camshaft on the opposite side must face the cylinder head cover.
View from the flywheel side