911 Targa (996) F6-3.6L (2004)
15. Fasten blocking device (special tool 9612) on the cylinder head.
Special tool fitting sequence:
A Fastening screw with star knob on cylinder head lug. Pull back B and C when tightening.
B Centering piece in groove of exhaust camshaft. Pull sword bolt (C) back when tightening.
C Sword bolt
16. Allocate camshafts; to do this, turn the pre-tensioned centre piece accordingly until the sword bolt can be fixed in the bearing bore.
17. Fasten sprocket wheel. Tightening torque 14 Nm (10.5 ft. lbs.)
18. Remove blocking device.
19. Fit camshaft closure caps (3 ea.) dry.
20. Fit closure cap on tensioning element (VarioCam).
Tightening torque 10 Nm (7.5 ft. lbs.)
21. Fit oil supply pump.
Note;
-
The oil extraction pumps on the cylinder heads are identical parts. Therefore, the installation position and direction of rotation must be correct.