911 Targa (996) F6-3.6L (2004)
Chain tensioner on cylinder bank 4 - 6
Installing Valve Tappets of the Cylinder Bank 4 - 6 - Engine Installed
Installing valve tappets of the cylinder bank 4 - 6 - Engine installed
1. Check guide for damage. Refer to: Checking guide for valve tappet.
2. Fit guide. Tighten pan-head screws (M6 x 35) from the inside to the outside. Tightening torque 10 Nm (7.5 ft. lbs.)
3. Lightly oil the valve tappet and fit it in the guide.
4. Lay the complete unit, camshafts with chain and tensioning element in the cylinder head. The groove or tab of the camshaft position sensor cover
must face upward If the allocation should be uncertain, e.g. chain jumped over, reallocation is necessary. Refer to: Completing camshafts, Serv.
No 15 05 33.