911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-261011.png)
Turn crankcase by 180°. Turn crankshaft clockwise until the bore U5 on the belt pulley is aligned with the fixing bore on the crankcase. Position
or fix with fixing pin (short) of special tool 9595.
18. Prepare preassembled connecting rod with piston of cylinder 2 for installation. Perform the following assembly steps as described from Step 8 to
Step 16.
19. Fitting piston and connecting rod in cylinder 3 Rotate crankshaft clockwise until bore U6 on the belt pulley is aligned with the fixing bore on the
crankcase. Position or fix with fixing pin (short) of special tool 9595.
20. Prepare preassembled connecting rod with piston of cylinder 3 for installation. Perform the following assembly steps as described from Step 8 to
Step 16.
Note;
-
Leave crankshaft at position U6 after fitting the piston and connecting rod in cylinder 3. This position is necessary for subsequent fitting of the
piston of cylinder 6.
21. Remove belt pulley.
Fitting pistons on cylinder bank 4 - 6
Note;
-
The crankcase half of cylinder bank 4 - 6 must be fitted before installation of the pistons.
Installation
1. Thoroughly clean sealing surface of the crankcase half of cylinder bank 1 - 3.
2. Ensure that the profile seals on the oil guide and the two seals left and right of the coolant duct are seated correctly.
