911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-261012.png)
3. Place centering mandrel, special tool 9645, on the take-up bore of the oil pump and turn the star knob clockwise until the centering mandrel is
braced in the crankcase half (oil pressure builds up in centering mandrel).
4. Apply a uniform bead of silicone approximately 1.5 mm wide to the cleaned sealing surface of the crankcase half of cylinder bank 4 - 6.
5. Before fitting the crankcase half, have a second person pull the drive chain out of the chain space using a wire.
6. Carefully set the crankcase half in place so that the sealing bead is not damaged.
7. Fasten crankcase half. Tightening torque 13 Nm (9.5 ft. lbs.). Immediately remove silicone material emerging in the area of the oil pan sealing
surface.
8. Relieve centering mandrel. Turn star knob anti-clockwise (oil pressure drops) and remove centering mandrel. Remove silicone residue.
9. Fasten engine holder, special tool 9589, to the crankcase half of cylinder 4 - 6 (3rd fastening point).
