911 Targa (996) F6-3.6L (2004)
Removal
1. Turn shop-made extractor into centre of piercing point of closure cap and pull off the cap.
Installation
1. Clean the camshaft bore.
2. Fit new cap dry and press in by hand as far as it will go.
Installing and removing closure caps at cylinder head 4 - 6 - pulley side
Removal
1. Turn shop-made extractor into centre of piercing point of closure cap and pull off the cap. Remove the upper closure cap; to do so, first undo the
tailpipe fastening clamp and twist the tailpipe downward. Pull off the closure cap.
Installation
1. Clean the camshaft bore.
2. Fit new cap dry and press in by hand as far as it will go.
3. Align tailpipe and tightening fastening clamp.
Installing and removing closure caps at cylinder head 4 - 6 - flywheel side
Removal
1. Turn shop-made extractor into centre of piercing point of closure cap and pull off the cap.
Diagram shows upper closure cap
Diagram shows lower closure cap