911 Targa (996) F6-3.6L (2004)
Installing ATF Filter
Installing ATF filter
1. Thinly coat gasket on the suction collar of the new ATF filter with Vaseline and install filter.
2. Clean ATF pan.
3. Fit ATF pan with new seal. Tighten the screws crosswise in several stages.
Tightening torque: 8 Nm (6 ft. lbs.)
4. Replace sealing ring for ATF drain plug and tighten screw.
Tightening torque: 22 Nm (16 ft. lbs.)
5. Fill in ATF. -> Go to Page 216 'Checking and topping up ATF (as of model year 2002)'
6. Engage cable on the retaining clips of the ATF pan.
7. Install cross member.
Tightening torque: 65 Nm (48 ft. lbs.)
8. Install rear underside panel.