911 Targa (996) F6-3.6L (2004)
2. Remove LWL module from the connector.
3. Place the tool for releasing the contact locking of the LWL module and lift the locking.
4. Pull LWL, e.g., -B- carefully in the -direction of the arrow- . If it is not possible to pull out the LWL, check again if the locking is completely
released.
-
Visual inspection of lockings, connector housing, and contacts for possible damage and if necessary, exchange the damaged parts.
Installing optical contacts on socket side
-
Remove the dust boot right before plugging.
-
Check the proper condition of the contact.
-
At a force of 10 N (7.5 ftlb.) the springs installed in the joint will be pressed together. This leads to an increase in attenuation, which could lead to
system impairment and system failure. Therefore, a maximum of 10 N (7.5 ftlb.) can be used to pull the LWL from the joint.
1. Insert the optical contacts -B- and -A- in the module until it engages audibly. Check the optical contacts for tightness.
2. Insert the module in the joint on the socket side.