911 Targa (996) F6-3.6L (2004)
11. On cylinder bank 4 - 6, connect cable plug of the oil level sender and the aluminium spacer sleeve -2-.
12. In vehicles with air conditioning, install air-conditioning compressor.
13. Position rubber sleeves with loose screw-type hose clamps on the left and right of the intake distributor and push as far as possible in the direction
of the intake plenum. Insert vacuum lines into rubber sleeves.
14. Install central intake distributor by spraying the left and right rubber sleeves with silicone spray and pushing the central intake distributor into
place. Align the rubber sleeves and tighten all four screw-type hose clamps -2-.
15. Install coolant bleeder hose -arrow- by pushing on the spring-band clamp and fastening the hose to the plastic flange.
Steps 6 - 17 refer to the adjacent Figure
16. Connect plug connection to central intake distributor -3-.
17. Clip switch-over valve of the tank ventilation -4- into the plastic clip and connect cable plug.
18. Install throttle body. To do so, position the throttle body with new sealing ring and tighten the four M6 x 25 hexagon-head bolts. Fit cable plug to
the throttle body.
19. Install air cleaner housing.
NOTE: Note the work instructions for disconnecting and reconnecting the battery.