911 Targa (996) F6-3.6L (2004)
2. Unclip the wiring harness of the injection valves from the 3 cable retainers on the fuel collection pipe -1- and set aside. Remove both cable plugs
of the oil pressure sensor -2-.
3. Unscrew the two M6 hexagon-head bolts of the fuel collection pipe.
4. Remove cable plugs of the injection valves by pressing in the wire clips and pulling off the cable plugs.
5. Pull the fuel collection pipe complete with the injection valves out of the cylinder head and place it on the cylinder head.
NOTE: Collect emerging fuel with a cloth.
6. Pull the retainers off the injection valves -A- and pull the injection valves out of the fuel collection pipe -B-. Make sure that all O-rings are present
on the injection valves. Collect emerging fuel with a cloth.
Installing Injection Valves Of Cylinder Bank 4 - 6
NOTE: Replace O-rings of the injection valves.