911 Targa (996) F6-3.6L (2004)
4. Route the wiring harness of the injection valves and clip it into the cable retainers on the fuel collection pipe -1-. Push on the two cable plugs of
the oil pressure sensor -2-.
5. Push cable plugs onto the injection valves by pushing on the cable plugs until they audibly engage.
6. Raise the engine again with the jack and then tighten the two collar nuts (a/f 18) on the engine mounts with the correct torque.
Tightening torque 85 Nm (63 ft.lb.)
7. Install air cleaner housing.
8. Connect the battery.