911 Targa (996) F6-3.6L (2004)
-
Select Air conditioning with/without corresponding to the equipment in the Modify PCM2 GW coding function selection and code with the F8
key.
Menu item
-
Country coding.
Function
Using this menu item, you can code the country code.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 GW in the PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 GW function selection and confirm with the >> key.
-
Select Country coding in the PCM2 GW Coding function selection and confirm with the >> key.
-
Select the relevant country coding from the menu item that is displayed and code it with the F8 key.
Menu item
-
MOST switch.
Function
Under this menu item, the MOST switch corresponding to the vehicle configuration can be coded.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 GW in the PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 GW function selection and confirm with the >> key.
-
Select MOST switch open/closed in the PCM2 GW coding function selection and confirm with the >> key.
-
Select MOST switch open/MOST switch closed from the menu displayed and code with the F8 key.
The following selection is available:
-
MOST switch open
-
MOST switch closed
Menu item
-
PCM2 code.
Function
It is possible to code the PCM2 code under this menu item after replacing the PCM2.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 GW in the PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 GW function selection and confirm with the >> key.
-
Select PCM2 code in the PCM2 GW coding function selection.
-
Take the PCM2 code from IPAS, enter it and code it with the F8 key.
Menu item
-
Production mode.
Function
The PCM2 is set to the Production mode ON low-power mode in the factory and this must be switched off when put into service.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 GW in the PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 GW function selection and confirm with the >> key.
-
Select Production mode in the PCM2 GW Coding function selection and confirm with the >> key.
-
Select Production mode OFF from the menu item displayed and code it with the F8 key.
The following selection is available:
-
Production mode on
-
Production mode off