911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-828005.png)
Removing and Installing the Passenger's Airbag Unit
Removing And Installing The Passenger's Airbag Unit
Removing passenger's airbag unit
WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units. Please observe the following points:
-
The airbag unit must always be deposited so that the airbag opening faces upwards.
-
If removed for an extended period, the airbag unit must be kept in a locked place.
-
Observe the safety regulations.
1. Remove ignition key.
2. Disconnect the battery and cover terminal or battery.
3. Remove the air guide at the bottom right.
4. Undo the airbag unit from below and remove it rearward to the passenger's seat.
5. Disconnect the electrical plug connection.
6. Pull out the hinge pin on the airbag unit and remove the panel.
Installing passenger's airbag unit
Tightening torque for fastening screws (2 screws M8 x 95): 20 Nm (15 ftlb.)
Removing and Installing the Side Airbag Unit
Removing And Installing The Side Airbag Unit
Removing side airbag unit
WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units. Please observe the following points:
-
The airbag unit must always be deposited so that the airbag opening faces upwards.
-
The airbag unit should be placed in a package or packed in film and, if removed for an extended period, stored under dry conditions in a
locked room.
-
Observe the safety regulations.
1. Remove ignition key.
2. Disconnect the battery and cover terminal or battery.
3. Remove door trim panel. Refer to Disassembling and assembling door trim panel".
INFORMATION:
-
Behind the "Airbag" inscription lies a screw M5 x 10 that is fastened on the fastening clip of the side airbag unit.
-
The fastening screws must always be replaced after removal.
4. Remove cover with "Airbag" inscription and unscrew the screw.
5. Disconnect electrical plug connection and undo fastening screws.
6. Carefully remove side airbag unit from the door.
