911 Targa (996) F6-3.6L (2004)
7. Deposit airbag unit correctly.
Installing side airbag unit
Left/right identification of the side airbag unit for installation:
-
Inscription R = Right door
-
Inscription L = Left door
-
Locking pin -A- must always point to the rear
-
The wire connection point -B- must always face the front
-
Fastening clip M5 -C- always to the rear
INFORMATION: The cover film behind the side airbag unit must not be damaged (protects against water leaking in).
1. Install airbag unit with the inscription "R" in the right-hand door and fasten.
2. Engage electrical plug connection.
Tightening torque for fastening screws (4 screws M6 x 16): 10 Nm (7.5 ftlb.), (1 screw M5 x 10): 6 Nm (4.5 ftlb.)
3. Reinstall the door trim panel.
Removing sensor for side airbag unit
WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units. Please observe the following points:
-
After an accident, the sensor of the triggered side airbag unit must be examined for damage.
-
The sensor must be replaced after the side airbag has been triggered for the third time.
INFORMATION: Sensors for triggering the side airbag unit are fastened on the inner lower side member on the left and righthand sides in the vehicle.
-
The cover strip and the support on the lower side member must be removed.