911 Targa (996) F6-3.6L (2004)
Note!
^
The coil spring is equipped with an approximately 50 mm long protective sheath at the top. This protective sheath is not yet present on
vehicles from the initial production run.
A Top
B 10 mm
C Protective sheath approximately 500 mm long
-
Place spring plate on the coil spring.
-
Place stop plate in the correct position on the spring strut mount. Screw new fastening nut onto the piston rod until approximately 1 to 2 threads
are visible above the fastening nut.
-
Position the spring strut mount for installation (correctly position spring strut mount with respect to the damper).
Note!
^
The mounts for the right and left sides are identical parts.
-The spring strut mount is positioned correctly if one of the 3 fastening pins is aligned with the stabilizer mounting saddle.
-Once the mount has been positioned correctly, tighten the fastening nut to 60 Nm (44 ft. lbs.). When tightening the fastening nut, hold at the piston
rod using a 7-mm open-ended wrench.
Note!
^
Never use an impact bolter to tighten the fastening nut.