911 Targa (996) F6-3.6L (2004)
Shift Cable: Service and Repair
Removing Selector Lever Cable
Removing selector lever cable
1. Removing selector knob.
2. Removing centre console.
3. Remove parking brake console.
4. Remove underbody panels (middle and rear).
5. Remove transmission support.
6. Remove plastic cover -A- around pinion shaft.
7. Remove transmission lever -A- from the transmission housing. To do this remove retaining clamp -D- from the pivot point. Undo the transmission
lever holder screws -C- and remove the transmission lever holder -B-.
8. Remove support bracket sleeve -A- on selector lever cable from support bracket -B-. To do this, press retaining clip -C- together and pull the
support bracket sleeve out of the support bracket.