911 Targa (996) F6-3.6L (2004)
Drive/Propeller Shaft: Service and Repair
Removal
Removal
Note!
^
Observe maximum joint angle of 20° when removing and fitting. Furthermore, the cardan joint must not be loaded at maximum deflection (stop).
1. Remove underbody panels (rear and centre).
2. Support manual transmission in installation position with the transmission jack and remove the transmission support.
A Transmission support
B Transmission holder
3. Fasten transmission to the transmission holder with the two fastening screws.
4. Detach cardan shaft at the transmission and press it off the transmission flange with two mounting levers.
5. Pull cardan shaft out of the splines of the central shaft and remove.
6. Remove bellows from the central shaft.