911 Targa (996) F6-3.6L (2004)
Drive/Propeller Shaft: Service and Repair
Installation
Installation
Install in reverse order, observing the following points:
1. Always replace bellows for cardan shaft.
2. Slide assembly sleeve 9255 over the shaft splines, lightly lubricate sleeve with Vaseline and push on the bellows to the stop.
A Assembly sleeve 9255
3. Grease bushing with approximately 3 g of Olista Longtime 3EP.
A Bushing
4. Grease splines of the cardan shaft with Olista Longtime 3 EP. Slide shaft into the central shaft splines and fit on the transmission side.
5. Push bellows forward until it engages in the groove of the central shaft. Check whether the bellows is seated properly by pulling on it.
A Bellows
B Cardan shaft
C Central shaft groove