911 Targa (996) F6-3.6L (2004)
Installation
1. Replace square sealing ring in mounting saddle.
2. Check flanged shaft for burrs and sharp edges on the transmission end of the shaft (arrow) and deburr if necessary.
3. Carefully insert flanged shaft into the transmission.
Note!
^
While being inserted, the flanged shaft must be carefully guided with the hand in order to prevent damage to the double sealing ring in the
transmission.
4. Refill rear-axle oil.
Tightening Torques
Tightening torques
Mounting saddle for flanged shaft to transmission (M6) = 23 Nm (17 ft. lbs.)
Drive shaft to flanged shaft (M10) = 81 (60 ft. lbs.)
Wheel to wheel hub = 130 Nm (96 ft. lbs.)
Removing and Installing Sealing Ring For Long Flanged Shaft
Removing and installing sealing ring for long flanged shaft
Tool
Removal
1. Remove long flanged shaft.