911 Targa 4S (997) F6-3.8L (2007)
3. Plug in connector -3- until it engages securely. Lay line along the motor.
4. Fold the closing aid holder upwards in the direction of the arrow. Make sure that the support strut -inset- for the closing aid is engaged properly.
Tighten fastening screws -1-. Tightening torque: 9.5 Nm (7.0 ftlb.)
Installing right electric motor for sunroof
INFORMATION:
-
Pull out ignition key.
-
Before installing the electric motor again, visually check the drive shafts for damage.
-
If the drive shafts have been severely damaged as a result of metallic abrasion, the drive shafts must be replaced as described below. >> Refer to
Disassembling and assembling frame for sunroof cover
-
If both motors have to be removed and installed, then the position of the holders must be checked and, if necessary, the holders must be adjusted in
accordance with the description: Refer to Adjusting holder unit (drive mechanism).
1. Push the gear wheel of the sunroof electric motor -2- between the shafts and press the motor onto the drive pipe.