911 Targa 4S (997) F6-3.8L (2007)
/f6-3.8l/Page-114012.png)
1. Unscrew the fastening screw -2- on the compressor.
2. Unscrew the fastening screw -3- at the disconnection point ahead of the rubber mounting and remove the line from the engine compartment.
Installing compressor-condenser line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
