911 Targa 4S (997) F6-3.8L (2007)
3.2. Push in the locating peg -1- of the support and check that it is seated correctly.
3.3. Tighten the fastening nuts -3- and fastening screws -2-.
- Tightening torque: 7.2 Nm (5.5 ftlb.)
4. Lay the floor covering over the support and engage.
INFORMATION: Ensure that belt strap can run properly.
5. Secure seat belt mount at left and right.
5.1. Screw in fastening screw -2- , seat belt and fitting -3- and spacer sleeve -4- on inner lower side member.
- Tightening torque: 50 Nm (37 ftlb.)
5.2. Press in cap -1-.
6. Install left footwell trim panel.
6.1. Insert footwell trim panel -3- ( -arrow A- ) and screw in the three fastening screws -2-.
- Tightening torque: 3 Nm (2 ftlb.)
6.2. Insert the fuse carrier cover -1- with both clips -4- into the lateral footwell trim panel -2- and clip in -arrow B-.