911 Targa 4S (997) F6-3.8L (2007)
7. Install right footwell trim panel.
7.1. Position footwell trim panel -3- ( -arrow A- ) and screw down with both plastic nuts -2-.
7.2. Secure floor covering -1- at the bottom in the area of the A-pillar -arrow B- .Use double-sided adhesive tape or suitable adhesive.
Subsequent work
INFORMATION: Only for vehicles with tyre pressure monitoring
1. Install rear wheel housing liner.
2. Install rear underbody cover.
3. Install reservoir.
4. Install air cleaner housing.
5. Install rear spoiler.
6. Install rear light at left and right.
7. Install auxiliary brake light.
INFORMATION: Only in the cabriolet.
8. Install roll-over bar.
INFORMATION: Only in the cabriolet.
9. Install frame for roll-over protection system.
INFORMATION: Only in the cabriolet.
10. Install frame for roll-over protection system.
11. Install relay carrier.
12. Install trim panel for seat well.
13. Install rear wall trim panel.
INFORMATION: Only in the coupe.
14. Install C-pillar trim panel.
15. Install rear side trim panel at left and right.
16. Install left and right scuff plate.
17. Install front seat at left and right.
18. Carry out work instructions after disconnecting the battery.
Removing and Installing Wire Harness For Battery Wiring
Removing And Installing Wire Harness For Battery Wiring
Tools