911 Targa 4S (997) F6-3.8L (2007)
Subsequent work
1. Fit the underbody panel.
2. Lower the vehicle.
Removing and Installing Short Halfshaft Flange
Removing and installing short halfshaft flange
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove right rear wheel.
3. Remove underbody panelling.
4. Remove right drive shaft.
Removing short halfshaft flange
Removing short drive shaft flange
1. Remove short drive shaft flange.
Tap out short drive shaft flange using a striker VW 771/1.
Removing short drive shaft flange
Installing short halfshaft flange