911 Targa 4S (997) F6-3.8L (2007)
Installing outer side-window seal (upper part)
Installing upper part of outer side-window seal
1. Position upper part of side-window seal.
INFORMATION: Use the Arrow marking on the bodyshell for guidance.
1.1. Fit upper part of side-window seal -1- with the slot onto the rear blind rivet for the T-bolt -2- and slide it backwards in direction of travel
-arrow A-.
1.2. Insert upper part of side-window seal -1- with the cut-out on the front blind rivet for the T-bolt -2- (-arrow B-).
2. Install upper part of side-window seal.
INFORMATION: Check that the sealing lip -3- on the lower part of the side-window seal is not trapped. Pull the sealing lip out with a plastic spatula if
necessary.
2.1. Rivet upper part of side-window seal -1- using rivets -2- (4.0 x 7.9).
Subsequent work
1. Install inner side-window seal. Refer to Removing and installing inner side-window seal.
2. Install roof joint cover strip (C-pillar cover). Refer to Removing and installing roof joint cover strip (C-pillar cover).