911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Cellular Phone: Service and Repair
Wire Routing
NOTE: Always insert suitable rubber grommets when routing wires through drill holes in sheetmetal panels.
Antenna cable
The antenna cable is routed from the passenger footwell across the right-hand A-post along the roof panel towards the B-post and to the antenna exit.
Make sure the antenna cable does not cause any clattering noise.
NOTE: The sun visor and courtesy light will have to be removed for fitting of the antenna cable.
D-Net wiring harness
The wiring is routed from the transmitter/receiver unit towards the front wiring harness. It is tied to the front-end wiring harness with standard tie-wraps.
In the strut area, a mark to aid assembly is attached to the wiring hamess.
Fit edge protector to strut tower area. Attach telephone wiring harness with wire clamp to wiring harness cover. Connect ground to ground point VI in
the cover hinge area. Fit end connector to D-Net wiring harness in transverse wall.
Connect power supply wires (terminal 15 and terminal 30) to Central Electrical System. terminal 30 is connected across a fuse to the screw-on terminal
at the Central Electrical System. terminal 15 is connected across a fuse to connector K 13.
The fuses are installed in a fuse holder in relay slot R 62.
Fusing of terminal 15: 7.5 A
Fusing of terminal 30: 7.5 A
