911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
CD Changer: Service and Repair
Retrofitting Procedure
Remove front compartment carpet, spare tire, protective cover, fuel tank and battery
No.
Operation
Instructions
1
Insert pop rivet nuts for
Scribe attachment points for CD changer bracket
attachment of the CD changer
on left-hand front end to side member. Using a 9.5 mm dia.
bracket into side member
drill bit, drill holes into side member according to scribe
marks. Insert M 6 pop rivet nuts into side member and rivet in place using a pop rivet nut gun,
2
Drill 20 mm dia. hole for
Scribe hole for routing of CD changer/radio
routing of connecting wire
connecting wire on bulkhead and drill to 20 mm dia.
3
Finish assembly of
Remove transport locks from CD changer.
CD changer
Cover open holes on CD changer using the self-adhesive sheets supplied. Fit interface to CD changer using
M 4 x 8 combination screws (4 pc.). Connect interface/CD changer wiring.