911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Radio/Stereo: Service and Repair
Resetting Antitheft Radio
Alpine CD-2 Radio
Built-in antitheft circuitry will render the audio system of the radio/CD-2 unusable if the power supply is disconnected or voltage drops below 5 volts.
When the radio/CD-2 is electrically reconnected, it will not operate until a security code assigned to the specific radio/CD-2 is correctly entered.
The security code is shown on the car radio identification card that is supplied to the customer with the radio/CD-2 owner's manual. This code must be
obtained before the power supply is disconnected. If a security code cannot be obtained from a customer, contact the Porsche Cars NA Warranty and
Service Technical Support Department by phone to obtain the security code.
Entering Security Codes
- When the CD player is switched on after the power supply was disconnected, the word "code" appears in the display. The 5-digit security code must
be entered by using the preset switches 1 thought 6.
- If the code is entered correctly the CD player is ready to function again. If the code is entered incorrectly in three consecutive tries, the display will
show "off". A waiting period of 24 hours is required before the CD player will accept another code entry. (Radio must be on the ignition key in radio
position).
Important
When entering the security code, the display changes to "IN". The code is processed as it is entered. Be sure to complete the 5-digit sequence even
when mistakenly pushing a wrong switch. For example, the code number sequence is 54 321 and you mistakenly enter 53 instead of 54. Complete
the entry anyway by pushing 321. The CD-2 player will not operate and "code" will be displayed. Re-enter the correct number sequence and the
CD-2 player will become operative.
To enter code 54 321, for example, you must push switch:
5 - 1x
4 - 1x
3 - 1x
2 - 1x
1 - 1x
Blaupunkt Reno II Radio
Built-in antitheft circuitry will render the audio system of the radio/CD-2 unusable if the power supply is disconnected or voltage drops below 5 volts.
When the radio/CD-2 is electrically reconnected, it will not operate until a security code assigned to the specific radio/CD-2 is correctly entered.
The security code is shown on the car radio identification card that is supplied to the customer with the radio/CD-2 owner's manual. This code must be
obtained before the power supply is disconnected. If a security code cannot be obtained from a customer, contact the Porsche Cars NA Warranty and
Service Technical Support Department by phone to obtain the security code.
Entering Security Codes
