911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Camshaft Housing (Left Side Shown) Part 3 Of 3
NOTE: Unless indicated otherwise, coat all aluminum plugs with Optimoly HT (copper paste) and press in flush. Do not use any other lubricant.
Removing And Installing Spray Tube On Camshaft Housing
NOTE: In case of bearing damage and when rebuilding the engine, the spray tubes must always be removed and cleaned thoroughly. If bearings are
damaged, the lateral oil ducts must also be cleaned (removed 6.7 mm dia. plug and opposite 6.3 mm dia. balls). The ball may be pushed out with a
threaded bar (M5) from the opposite side. Balls that do not retain a press-fit should be replaced by a plug.
Removing The Spray Tubes
Removal
Pre-drill lateral plugs (8.15 mm dia.) and upper plug (12.5 mm dia.) with a 4.8 to 5 mm dia. drill to a depth of approximately 9 mm and tap in an M 6
thread with a bottoming tap. Pull out plug with M 6 screw and spacer sleeve.
Positioning Spray Tube With Auxiliary Tool
