911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
2. Undo the fastening screws of the contact unit.
3. Take out heating and air conditioning control with Special Tool V160 and release tie-wraps of connectors.
4. Pull forward and disconnect the electrical plug connections.
5. Remove the contact unit.
Installation Of Contact Unit
-
Set the front wheel to the straight-ahead position before refitting the contact unit.
-
Ensure that the exact center position (arrows) of the contact unit is maintained.
Installation Of Steering Wheel
1. Refit the steering wheel with the wheels in the straight-ahead position or in accordance with the marking so that the upper spokes of the steering
wheel are horizontal.
Caution: Do not trap the cable of the contact unit.
2. Fit hexagon nut with spring washer and tighten to 46 Nm.
3. Install driver's airbag unit. Use new fastening screws and tighten to 10 Nm (7.5 ft.lb.).
4. Check horn for operation.
