911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Steering Gear: Service and Repair
Removal
1. Separate universal joint (steering shaft) from steering gear.
-
To do so, remove floorboard of pedal cluster.
-
Undo clamping screw and push joint upwards.
NOTE:
-
Fix or remove steering wheel in straight ahead position of road wheels.
-
If this requirement is not observed, the airbag contact unit must be brought into the center position after the steering gear has been fitted.
2. Remove underside panel.
3. Press tie-rod ball joint off the steering arm.
-
Use a suitable puller, e.g. Nexus 168-1 (No. 1), together with a 12 mm cap nut (No. 2/Special Tool VW 267 a).
NOTE:
-
Start by turning tie-rod towards the front (arrow).
-
Then angle off ball joint (ball pin) according to the Figure and extend it in this position.
4. Repeat operation on other side.