911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Wiper Motor: Service and Repair
Removing and Installing Wiper Motor (With A/C System)
Removal
1. Disconnect battery and cover battery or terminals.
NOTE: Follow safety precautions for work on vehicles with airbags.
2. Remove steering wheel and steering column panel.
3. Remove tachometer and large and small instrument cluster.
4. Remove air guide. Disconnect six-pin connector from wiper motor.
5. Unhook left pneumatic spring of luggage compartment lid and support luggage compartment lid.
6. Extract refrigerant with service equipment.
7. Remove cover of heater / A/C unit (old type with two screws and washers: new type with clamping spring).
8. Disconnect central electrical system.
9. Remove wire harness cover.
10. Unplug connector from lid of fan housing and lay central electrical system on fender (the fender must be protected by a cover).
11. Unplug cable connector from final stage of fan.
12. Remove firewall.
13. Disconnect A/C lines from expansion valve. Immediately insert air-tight plugs in ends of all lines and connections. Loosen retaining clip.
14. Remove rear wheel housing liner on front left fender.
15. Disconnect hose clip from fluid reservoir. Undo mounting screw between wheel housing A/C lines and luggage compartment A/C lines.
Immediately insert air-tight plugs in ends of all lines.
