911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
16. Move A/C lines to side from wiper mount.
17. Release mounting nut of linkage, holding a 21 mm open-end wrench against linkage.
Tightening torque: 22 ± Nm (16 - 1.5 ft lb).
18. Release mounting screws. Tightening torque: 11 Nm (8 ft lb).
19. Remove wiper motor through installation opening of tachometer.
Installation
NOTE: Installation of the wiper motor is much easier if the motor is fixed in position with a stud bolt (sawn-off screw) and a nut. After fixing the motor,
fasten it in place with 2 screws. Then unscrew the nut and stud bolt and insert the third screw.
1. Connect battery and switch wiper motor on and off (park position).
2. Install linkage. Cable and linkage must form a straight line.
3. Switch on wiper motor and check wiper positions.
4. Disconnect battery again and install the parts that you have removed. Use new O-rings and wet them with refrigerant oil.
5. Replace the two self-locking screws of the airbag unit in the steering wheel.
NOTE: To remove the crank mechanism of the wiper, the heater / A/C unit must be removed.
