911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
NOTICE: Heat protection panels not fitted correctly
-
Risk of damage to adjacent parts
-
Make sure the heat protection panels overlap correctly.
-
Replace damaged or distorted heat protection panels.
-
Check heat protection panels for deformation, fixing of the aluminium braided cord, tears and missing or damaged fixing tabs.
-
More than 80% of the total sealing area must be sealed without gaps.
1. Before installing the rear apron, the following steps must be carried out:
1.1. Check heat shields on the vehicle and replace them if necessary. Refer to Removing and installing rear bumper.
1.2. Check position of rear lid and re-adjust it if necessary. Refer to Adjusting rear lid.
1.3. Check fastening points (fastening nuts) on the rear apron and replace them if necessary.
INFORMATION: Two persons are needed to disengage and engage the rear apron.
2. Position rear apron on the vehicle until the electric plug connection -1- can be connected -arrow-.
3. Position the rear apron -2- fully on the vehicle -arrow-.