911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Screw down fastening screws -1- at the top and bottom of the rear apron -2-. Tightening torque: 2.8 Nm (2.0 ftlb.)
5. Screw in fastening screws -1- at the sides of the rear apron -2-. Tightening torque: 2.8 Nm (2.0 ftlb.)
6. Insert expanding clip -2- and screw in expanding pin -1-.
Dimensions of tailpipes
Gap dimensions of tailpipe
CAUTION: Tailpipe not fitted correctly
-
Components can heat up
-
Observe exact gap dimensions.
-
After the test drive, check the gap dimensions again and re-adjust if necessary.
1. Check gap dimensions from tailpipes -1- to rear apron -2- and replace tailpipes if necessary. Refer to Removing and installing tailpipe.