911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
Gap dimension: 20.6 mm
-
Gap dimension: 19.6 mm
-
Gap dimension: 21.1 mm
-
Gap dimension: 10.2 mm
-
Gap dimension: 12.1 mm
Subsequent work
1. After fitting the rear apron, check heat protection shields for correct assembly, and correct if necessary. Refer to Removing and installing rear
bumper.
2. Install the rear light. Refer to Removing and installing rear light.
3. Install rear wheel housing liner. Refer to Removing and installing rear wheel housing liner.
4. Check gap dimensions at rear, and adjust if necessary. Refer to Diagram - body gap dimensions
Removing and Installing Rear Retaining Strip
Removing And Installing Rear Retaining Strip
Technical values
Preliminary work
Remove the rear apron. Refer to Removing and installing rear apron.
Removing rear retaining strip