911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Keyless Entry Transmitter: Service and Repair
Disassembling and Assembling Remote Control
Disassembling And Assembling Remote Control
Disassembling remote control
INFORMATION:
-
In the event of a complaint (remote control buttons too easily pressed), the silicone pad and buttons can be replaced with modified spare parts.
-
To prevent irreparable damage to the PCB as a result of an electrostatic discharge, always observe the following points:
-
Only rework the remote control on a workbench or toolbox.
-
Before opening the remote control, place both hands on the workbench or on the toolbox to ground yourself (place both hands briefly on the
workbench).
-
Then start working immediately.
-
The PCB should only be held carefully at the edge.
1. Insert a small screwdriver between the cover and the lower part of the remote control -arrow- and carefully lift the lid off.
2. Remove silicone pad -1- with the printed circuit board (PCB) from the remote control housing.