911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
3. Remove PCB -2- from the silicone pad -1-.
4. Lift up buttons (two or three, depending on the vehicle type) and pull them out of the remote control housing.
Assembling remote control
INFORMATION: In the event of a complaint (remote control buttons too easily pressed), the silicone pad and buttons can be replaced with
modified spare parts.
1. Engage new buttons in the remote control housing.
INFORMATION:
-
The PCB should only be held carefully at the edge.
-
Immediately after removal, insert the PCB back into the silicone pad and assemble the remote control.