911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Convertible Top Deck Lid Seal: Service and Repair
Removing And Installing Seal For Convertible-Top Compartment Lid
Removing seal for convertible-top compartment lid
1. Move convertible top to position shown in the illustration.
2. Pull seal for convertible-top compartment lid off the flanges at the side panels -Arrows A- and at the corner pieces -Arrows B-, as well as off the
flanges connecting to the engine compartment bulkhead -Arrows C-.
Removing seal for convertible-top compartment lid
Installing seal for convertible-top compartment lid
INFORMATION:
-
Before replacing, check the existing seal for signs of damage (areas torn, crushed, etc.). If there are signs of damage, the seal must be replaced.
-
The seal is pressed onto the flange without any additional sealants.
1. Lay seal for convertible-top compartment lid evenly along the flange. Position and press the seal without tension onto the flanges at the side panels
-Arrows A-, at the corner pieces -Arrows B- and onto the flanges connecting to the engine compartment bulkhead -Arrows C-.
INFORMATION: Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.