911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
3.1. Dip the ends of the hydraulic lines -2 and 3- fully into a container filled with Pentosin.
3.2. Move pump motor to its lower initial position.
To do this, connect the -narrow contact- to 12V (+) and the -wide contact- to ground (-). The lower initial position is reached when the piston
in the pump unit moves to the mechanical stop and the amperage rating exceeds 10A. The amperage is measured using the digital multimeter
Bosch MMD 302.
3.3. To prevent Pentosin from running out of the hydraulic lines, -2 and 3-, hold the hydraulic lines up straight after removing them from the
container.
Filling the hydraulic cylinder
1. Hold the two hydraulic cylinders -1- vertically and use a syringe to fill each hydraulic cylinder with 5 ml of Pentosin.