911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Air cleaner housing and pressure pipe
Component overview
Component overview
1
- Vacuum line for brake booster
2
- Connection point for vacuum line on vehicle side (plug-in coupling)
3
- Combination holder
4
- Cable holder
5+6
- Micro-encapsulated Torx screws. 5 = M6 x 10/6 = M6 x 16. Always replace after loosening.
7
- Tandem pump at the left exhaust camshaft
8
- Exhaust sensor line
Removing vacuum line
1. Pull adapter -2b- - or hose piece if an adapter -2b- is not used - together with the thin vacuum line out of the branch piece of the vacuum line -1-.
Disconnect vacuum line -1- from the vacuum line on the vehicle side in area -2- at the plug-in coupling. To do this, remove the retainer -2a- and
pull the vacuum line out of the plug-in coupling while releasing it at the same time.
Vacuum line connections
2. Release vacuum line -1- from combination holder -3- (open combination holder -3-).
3. Unclip lines from the retaining clip -4-.
4. Remove vacuum line -1- at the tandem pump -7-. To do this, loosen the two Torx screws -5 and 6- (Torx E10) -from the underside when the
vehicle is raised-. Counter at the hexagon on the combination screw behind it (behind the holder) when loosening the Torx screw -5-. You only
need to counter if a combination screw is fitted under the holder (introduced only in the current model series).