911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Remove coolant hoses.
2.1.
Remove supply hose (reservoir to engine) -3-. To do this, open the spring band clamp -4- and pull off hose.
Coolant supply hose and left Henn coupling
2.2.
Remove large coolant hose -2-. Remove spring clamps on the Henn couplings and pull off hose. Make sure that the spring clamps are not
overstretched.
Installation position of coolant hoses and reservoir
3. Pull off coolant hoses at the coolant reservoir -1-.
3.1.
Pull off supply hose -2- and unclip it from the bracket.
3.2.
Open the spring band clamp on the breather hose -3- and pull off the hose.
Coolant hoses at the reservoir
4. Remove engine coolant level sensor -2-. To do this, pull off the cable plug, turn the sensor on the reservoir 90° anti-clockwise (bayonet lock) and
pull it out of the reservoir.