911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Screws on coolant regulator cover
4. Fit cap -1- with new O-ring.
5. Position and tighten Torx screws (M6) -Arrows-. - Tightening torque: 10 Nm (7.5 ftlb.)
Camshaft housing cover
6. Fit retaining bracket -2-. - Tightening torque: 10 Nm (7.5 ftlb.)
7. Place vacuum line -1- on vacuum pump flange.
8. Position and tighten Torx screws (M6) -Arrows-. - Tightening torque: 10 Nm (7.5 ftlb.)
Vacuum pump line
9. Place spring clamp on the Henn coupling -1-.
Information
Check Henn coupling O-rings and replace them if necessary.
Clean plug connection and coolant hoses before assembly.
Coat O-rings and coolant hoses with Kluberplus Gel (Part No. 000.043.205.93).
Remove stoppers before fitting the coolant lines and hoses.
Information
The coolant hoses must engage audibly when pushed into the flanges (Henn coupling).