911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Water Pump: Service and Repair
Removing and Installing Coolant Pump
Removing and installing coolant pump
Information
Overview
Overview of coolant pump
1 - Coolant pump
2 - Screws
3 - Seal
4 - Coolant distributor housing
Preliminary Work
1. Remove pressure pipe.
2. Remove air cleaner housing.
3. Remove rear apron.
Danger
Parts of the exhaust system become extremely hot!
Danger of burns
Permanent scarring of the skin
-
Do not begin work until the exhaust system has cooled down completely.
-
If it is imperative that you work on the hot exhaust system, ensure that you wear fire-resistant and heat-resistant protective gear.
4. Remove rear silencer.
Danger
Risk of engine falling down.
Danger of fatal injury, material damage.
-
Support the engine with the prescribed tool.
5. Remove engine carrier.