911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Relief groove on main bearing 7
Information
Cover the chain slot briefly when fitting so that parts do not fall into the crankcase.
30. Insert the crankcase half carefully over the preassembled through bolts on thrust blocks 2, 3, 4 and 5, while at the same time getting another person
to pull the chain upwards through the chain slot.
31. Remove restraining straps again.
32. Join the crankcase halves and secure them with six new lock nuts with washers. Distribute the lock nuts evenly all around the joint and tighten by
hand.
Lock nuts on cross bolt connection
33. Insert the prepared through bolts for crankcase half 4-6 and hold them securely.
Inserting through bolts
34. Slide the conical sleeve of special tool assembly sleeve 9511 with an oiled O-ring to the end of the thread.