911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Small oil/water heat exchanger
3.1.
Unscrew screws -1- and remove oil/water heat exchanger -2-.
Installing oil/water heat exchanger
Installing large oil/water heat exchanger
1. Replace O-rings.
1.1.
Clean sealing faces for large oil/water heat exchanger, remove escaping oil and coolant from the engine housing.
Insert O-rings -1- and grease with Kluber Syntheso Glep (Part No. 000.043.204.68).
O-rings for oil/water heat exchanger
2. Install oil/water heat exchanger (cleanliness is essential).
2.1.
Lift large oil/water heat exchanger and insert it in installation position. Fit and tighten screws -1-.
-
Tightening torque: 10 Nm (7.5 ftlb.)
Large oil/water heat exchanger
3. Connect lines to the oil/water heat exchanger.
3.1.
Connect coolant vent lines -1- to the oil/water heat exchanger.