911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
-
Damage will be caused through heat build up if deformed heat shields are installed.
-
Check heat shields for deformation, fixing of the aluminium braided cord, tears and missing or damaged fixing tabs.
-
Damaged or distorted heat shields must be straightened or replaced.
2. Fit heat protection panels at the sides by screwing on and tightening the two speed nuts on each one. - Tightening torque: 3.5 Nm (2.5 ftlb.)
CAUTION:
Risk of engine dropping down.
-
Danger of fatal injury and damage to property.
-
Secure the engine with a suitable mounting jack.
3. Lift the engine with the mounting jack.
4. Fit and tighten M12 collar nuts on the engine mountings. - Tightening torque: 85 Nm (63 ftlb.)
5. Remove mounting jack.
Subsequent work
1. Install the two charge air coolers.
2. Install bumper.
3. Install rear apron.
4. Install rear wheels using special tool socket-wrench insert P300.
5. Install air cleaner housing.