911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Condenser HVAC: Service and Repair
Removing And Installing Condenser
Technical values
Removing the condenser
1. Unscrew the two fastening screws -1- holding the air guide for the condenser.
2. Pull the air guide forward and disengage it at the condenser -A-.
INFORMATION: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
3. Unscrew the two fastening screws -2- for the refrigerant lines.
4. Unscrew fastening screw -3-, lift the condenser and disengage from radiator bracket.
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.